Alpine Electronics KTP-445U Amplifiers

Alpine Electronics KTP-445U Amplifiers 

Maybe your audio system suits you pretty well, but lacks the clean power you need to really enjoy your music. Maybe you also don鈥檛 want a big, current-hungry amp that robs precious cargo space and empties your bank account. If that describes you, there is a solution.

The 鈥淗ead Unit Power Pack鈥 by Alpine is an add-on 4-channel amplifier for use with virtually any aftermarket radio or OEM system. Best of all, it鈥檚 small enough to mount behind the dash near your radio! Rated at 45 watts per channel at either 2 or 4 ohms, the power pack gives your system a nice power boost, and it sells for only $149.95 in the U.S. or $179.95 in Canada.

Features

The KTP-445U is a basic rectangular amp measuring 7.5-inches long, 2.5-inches wide, and 1.5-inches high. The small size and slender shape allows it to be hidden almost anywhere, so you don鈥檛 lose cargo space, and it鈥檚 light enough that you can mount it on any flat surface using hook and loop fasteners. Both ends of the amp have connections for the included wiring harnesses and the 15-amp mini ATC fuse and gain controls. Pre-amp inputs are also included for typical balanced high-level and RCA connections. The low level inputs are handy for using the amplifier in applications that don鈥檛 have a traditional source unit (motorcycles and ATVs), where you would use an MP3 player as your source. There is also a switched 12-volt output wire to control additional amplifiers, and the amp is bridgeable for 2- and 3-channel configurations. Thoughtfully, the harnesses are long enough for a variety of mounting locations without needing to add wire.

The KTP-445U is equipped with built-in crossovers to select the front and rear channels. Available crossover frequencies are 60, 80, and 120 Hz. Rubber plugs at the bottom of the amplifier cover the frequency filters, 2- or 4-channel input selector switches, and either high level or RCA inputs. The amplifier is a Class D design for high efficiency operation, but it is designed to drive either 2 or 4 ohm loads - making it compatible with virtually any OEM or aftermarket speaker system.

Listening

The KTP-445U adds noticeable power to your system compared to a typical head unit, and sounds good doing it. The little amp adds virtually no additional character, and does exactly what a good amp should - faithful reproduction of the recording with adequate power. The amp has no audible noise floor, and draws very little current.

Alpine Electronics KTP-445U Amplifiers Alpine Electronics KTP-445U Amplifiers

Performance / Bench Measurments

On the test bench the KTP-445U performs like a typical Alpine amplifier. As I suspected, the frequency response is exceptionally flat, and the signal-to-noise ratio is excellent. The input sensitivity has plenty of adjustment range to handle virtually any input source, and even after hours of fairly high volumes, the amp is barely warm.

Conclusion

While many of us have been brainwashed with the 鈥渁mps are big and go in the trunk鈥 ideology, the Alpine KTP-445U makes us re-think this. Sure, you aren鈥檛 going to win any SPL contests with it, but the high efficiency design, ultra compact size, and startlingly good sound might make it the perfect amplifier for you.

Alpine Electronics KTP-445U Amplifiers

Technical Data

The following power measurements were obtained using industry standard methods. (1 kHZ @ 1.0% THD+N - Battery voltages shown +/- 0.2 V)

Manufacturers Rated Power    Actual Measured Power
@  1.0% THD+N                  @ 14.4 V Battery   
@  1.0% THD+N                  @ 12.6 V Battery 
  45 x 4 @ 4 Ohms      48 x 4 @ 4 Ohms     37 x 4 @ 4 Ohms

  45 x 4 @ 2 Ohms      45 x 4 @ 2 Ohms     38 x 4 @ 2 Ohms

Signal to Noise Ratio referenced to 2V output.
(CEA-2006A)  (1 watt @ 4 ohms)    -89.2 dBA
Signal to Noise Ratio referenced to full 4 ohm output.     -106.0 dBA
Distortion at rated power     0.6%
CEA-2006A rated 4 ohm Power (minimum power per channel developed over the entire audio bandwidth)     47 watts/ch
Maximum Efficiency at full 2 ohm power per ch.    82.8%
Idle Current (warm)    0.5 A
Maximum Current @ full power 2 ohms per ch.    16.2 A
Frequency Response (-3dB)    10 Hz 鈥 46 kHz
Stereo Separation (Crosstalk)    -76.7 dB @ 5 kHz

4 Ohm Power vs THD

Max Flat - Freq Response Crossover Range - Freq Response

Related Articles

Quick Drive 鈥 2025 Chevrolet Blazer EV SS Quick Drive 鈥 2025 Chevrolet Blazer EV SS
The Skinny: The 2025 Chevrolet Blazer EV SS is not only the most powerful Blazer EV, but it鈥檚 the fastest SS (Super Sport) model every built by...
Is Subaru planning an STI return? Is Subaru planning an STI return?
My first thought upon reading the headline for this story is don鈥檛 get your hopes up. But a recent Car and Driver story has me thinking it could...
Your car is probably not stolen. Probably. Your car is probably not stolen. Probably.
You likely don鈥檛 give it a second thought, but there is a remote chance the car you鈥檙e driving 鈥 the one you paid for and completed reams of paperwork...
Aasbo Takes FD Round 1, New Track for Round 8 Announced, Larry Chen Inducted Into FD HoF Aasbo Takes FD Round 1, New Track for Round 8 Announced, Larry Chen Inducted Into FD HoF
Long Beach is always a tone-setter for the Formula DRIFT season. It鈥檚 tight, fast, and leaves little room for mistakes. That much hasn鈥檛 changed, but...
Will Genesis build these stunning concepts? Will Genesis build these stunning concepts?
If looking at the latest Genesis X Gran Coupe and X Gran Convertible concepts gives you a feeling of d茅j脿 vu, don鈥檛 worry, it鈥檚 a perfectly normal...
Toyota Discontinues GR Supra Toyota Discontinues GR Supra
I鈥檓 not saying we here at 伊人直播 are going to dive head-long into the prediction business, but we really nailed it when we said on the latest episode...